To repair hard drive technology you must have part step-by-step logic and part intuition. In this article, we are going to discuss a problem that misleads many because of the message that it displays. The error points to a faulty hard drive but it is really something else.
First, the computer boots and when it reaches the point where it displays, "Scanning IDE drives" and suddenly an unexpected error occurs: "No drive is connected to the FastTrak controller. The BIOS is not installed." Since your computer was working up to this point, you might say that the hard drive has died. After all the computer says that no drive is connected but you know that the drive is connect because it was working earlier.
In this particular situation, there is one clue to the source of the problem. The mention of the FastTrak controller is the clue. FastTrak is a SATA RAID controller made by Promise Technology. The probability that you have a RAID configuration is low in this case. I say this because of the second clue: This BIOS is not installed message. This tells me that the BIOS for RAID devices has not been installed so you have a simple IDE or SATA configuration.
Finally, the problem exists because you have no RAID drives plugged into your motherboard but your system setup has the RAID controller enabled. Just enter your BIOS setup and disable the Promise RAID controller and everything should begin to work properly. Every now and then a problem will surface like this one that will mislead the beginning computer owner. Hopefully, articles like this one and others will lead you down the path to your desired solution.
To get more information on hard drive repair or to get expert help on hard drive data recovery options, click here: repair hard drive.
Bird Poop On Concrete Porch
No comments:
Post a Comment